- Design Studio 3.0 Manual
- Commissioning an Installation
- Using the Color Picker
-
Getting Started
-
Commissioning an Installation
- Commissioning Workflow
- Creating an Installation
- Managing N4 Hubs
- Building Groups
- Adding Devices
- Dividing Linear Runs Into Groups
- Using the Color Picker
- Managing Lighting Power-Restore States
- Building Scenes
- Building Shows
- Programming Ketra Keypads
- Enabling Sensor Control
- Enabling Emergency Lighting
- Integrating Third-Party Lighting
- All Analog Integration Profiles
- DMX Integration
- Integrating with Lutron
- Publishing: Saving Configurations to Devices
-
Maintaining an Installation
-
Saving Your Progress
-
Troubleshooting
-
Appendices
3rd Party Outputs
Note: Not available in Ketra with HomeWorks QS installations.
In a Ketra Only installation, the 3rd Party Outputs tab is available after you have configured an N3 Satellite for analog or DMX output. On this tab, you can adjust the voltage output of a 0-10V output, switch the output state of a sustained contact closure, or adjust output configurations for a DMX master.
Even though third-party outputs are often in the same groups as Ketra lights, they can have entirely different settings in a given scene.
You cannot use Design Studio to assign default states to third-party lighting, so the 3rd Party Outputs tab is grayed out on the Lamps tab.