- Design Studio 3.0 Manual
- Saving Your Progress
- Two Ways to Save
-
Getting Started
-
Commissioning an Installation
- Commissioning Workflow
- Creating an Installation
- Managing N4 Hubs
- Building Groups
- Adding Devices
- Dividing Linear Runs Into Groups
- Using the Color Picker
- Managing Lighting Power-Restore States
- Building Scenes
- Building Shows
- Programming Ketra Keypads
- Enabling Sensor Control
- Enabling Emergency Lighting
- Integrating Third-Party Lighting
- All Analog Integration Profiles
- DMX Integration
- Integrating with Lutron
- Publishing: Saving Configurations to Devices
-
Maintaining an Installation
-
Saving Your Progress
-
Troubleshooting
-
Appendices
Saving With Internet Access
- Sync regularly. To sync, close out of the installation by exiting Design Studio or returning to the Existing Installations list from the sidebar. This overwrites the cloud backup with your local copy of the installation.
- Click Publish and Save whenever recommended by instructions in this manual, and when you wrap up your changes. This requires communication with every device in the installation and may take a substantial amount of time in large installations. Unfortunately, there is no way to publish a subset of changes. Because of the time delay involved, we do not recommend regular publishing during commissioning.