- Design Studio 3.0 Manual
- Commissioning an Installation
- Commissioning Workflow
-
Getting Started
-
Commissioning an Installation
- Commissioning Workflow
- Creating an Installation
- Managing N4 Hubs
- Building Groups
- Adding Devices
- Dividing Linear Runs Into Groups
- Using the Color Picker
- Managing Lighting Power-Restore States
- Building Scenes
- Building Shows
- Programming Ketra Keypads
- Enabling Sensor Control
- Enabling Emergency Lighting
- Integrating Third-Party Lighting
- All Analog Integration Profiles
- DMX Integration
- Integrating with Lutron
- Publishing: Saving Configurations to Devices
-
Maintaining an Installation
-
Saving Your Progress
-
Troubleshooting
-
Appendices
Ketra Only (Commercial)
Ketra Only installations have an expanded range of features to support an entire installation’s needs. A typical workflow is as follows:
1. Create an Installation (see Creating an Installation)
2. Enable API Authentication on N4 Hubs (only if commissioning without Internet access)
3. Configure Network Settings for N4 Hubs (As needed) (see Managing N4 Hubs)
4. Build Groups
5. Add Devices
6. As needed:
- Divide Linear Runs into Groups
- Manage Power-On Lighting States
- Build Scenes
- Build Shows
- Assign Scenes and Shows to Keypads (see Programming Ketra Keypads)
- Configure Emergency Lighting (see Enabling Emergency Mode Lighting)
- Configure Sensors and Other Inputs (see Enabling Sensor Control, All Analog Integration Profiles, and DMX Input)
- Integrate Third-Party Lighting and Other Outputs (see All Analog Integration Profiles, and DMX Output)