- Design Studio 3.0 Manual
- Commissioning an Installation
- Integrating with Lutron
-
Getting Started
-
Commissioning an Installation
- Commissioning Workflow
- Creating an Installation
- Managing N4 Hubs
- Building Groups
- Adding Devices
- Dividing Linear Runs Into Groups
- Using the Color Picker
- Managing Lighting Power-Restore States
- Building Scenes
- Building Shows
- Programming Ketra Keypads
- Enabling Sensor Control
- Enabling Emergency Lighting
- Integrating Third-Party Lighting
- All Analog Integration Profiles
- DMX Integration
- Integrating with Lutron
- Publishing: Saving Configurations to Devices
-
Maintaining an Installation
-
Saving Your Progress
-
Troubleshooting
-
Appendices
Integrating with Lutron
Design Studio 3.0 supports LAN (local area network) integration with HomeWorks QS and Quantum control systems. After integration, these systems will be able to control Ketra by playing scenes and shows, raising/lowering intensity, and toggling power for Ketra groups.
Both types of integration (HomeWorks and Quantum) require that you commission an installation in Design Studio and then import it into the appropriate Lutron commissioning software (HomeWorks QS for HomeWorks, Q Design for Quantum). Specific instructions and references for each are included in the following sections.
Note: If you import a Ketra installation into the Lutron software and subsequently make changes in Design Studio, you will need to re-import the installation.