- Design Studio 3.0 Manual
- Getting Started
- Design Studio Overview
-
Getting Started
-
Commissioning an Installation
- Commissioning Workflow
- Creating an Installation
- Managing N4 Hubs
- Building Groups
- Adding Devices
- Dividing Linear Runs Into Groups
- Using the Color Picker
- Managing Lighting Power-Restore States
- Building Scenes
- Building Shows
- Programming Ketra Keypads
- Enabling Sensor Control
- Enabling Emergency Lighting
- Integrating Third-Party Lighting
- All Analog Integration Profiles
- DMX Integration
- Integrating with Lutron
- Publishing: Saving Configurations to Devices
-
Maintaining an Installation
-
Saving Your Progress
-
Troubleshooting
-
Appendices
How to Use This Manual
D.S. 3.0 Manual Basics
This manual applies to:
- Design Studio 3.0 and firmware version 1.16 (For updating firmware, see Updating Firmware)
- Installations that use Ketra N4 Hubs to communicate
This manual does not apply to:
- Earlier versions of Design Studio or Ketra firmware
- Installations that use a Ketra N1 Network Dongle to communicate
- Lutron’s Homeworks QS software (Documentation on integrating Lutron with Ketra using Homeworks QS is available through Lutron)