- Design Studio 3.0 Manual
- Commissioning an Installation
- Enabling Emergency Lighting
-
Getting Started
-
Commissioning an Installation
- Commissioning Workflow
- Creating an Installation
- Managing N4 Hubs
- Building Groups
- Adding Devices
- Dividing Linear Runs Into Groups
- Using the Color Picker
- Managing Lighting Power-Restore States
- Building Scenes
- Building Shows
- Programming Ketra Keypads
- Enabling Sensor Control
- Enabling Emergency Lighting
- Integrating Third-Party Lighting
- All Analog Integration Profiles
- DMX Integration
- Integrating with Lutron
- Publishing: Saving Configurations to Devices
-
Maintaining an Installation
-
Saving Your Progress
-
Troubleshooting
-
Appendices
Enabling Emergency Mode Lighting
Note: This section applies to Ketra Only installations. In Ketra with HomeWorks QS installations, any emergency power relays should be linked to the Lutron HomeWorks QS processor and configured using HomeWorks QS, not Ketra Design Studio.
In the event of an emergency, any Ketra lights configured for Emergency Mode will do the following:
1. Go to their restore states (Restore states are covered in detail in Managing Lighting Power- Restore States.)
2. Ignore any and all commands from user input, timeclock events, etc.
3. Remain in their restore states until they receive confirmation that they are no longer in an emergency setting.