Devices and Features
- Ketra scenes and shows can be controlled from any HomeWorks QS trigger (e.g., button press, timeclock event, occupancy sensor).
- HomeWorks QS keypad raise or lower control of Ketra groups HomeWorks QS keypad LED feedback of Ketra scenes
- Ketra groups can be controlled from the Lutron Connect app
- Ketra groups can be controlled through voice control (e.g., Amazon Alexa, Google Home)
Required Devices
- HomeWorks QS processor with firmware version 14.0 or later
- Lutron Connect Bridge
- Ketra N4 hub with firmware version 2.0 or later
- HomeWorks QS designer version 14.0 or later
- Ketra Design Studio version 3.0 or later
Supported Devices
- Ketra model numbers starting with “HW-”: Lamps (A20, S30, S38)
- Downlights (D3, D4R)
- Linear luminaires (G2, P4, L3I, L4R)
- N3 satellite
- N3 DMX output
- Ketra N4 hub (required for system communication)
- Ketra devices require firmware version 2.0 or later
- HomeWorks QS processors require firmware version 14.0 or later
- Lutron Connect Bridge (e.g., CONNECT-BDG-1, CONNECT-BDG2-1)
Devices Not Supported
- Ketra model numbers that do not start with “HW-”
- Integration with Ketra products via N3 inputs/outputs
- Ketra X2 keypads
- Ketra virtual keypads or the Ketra app
- Integration with Ketra products via telnet
- Ketra emergency mode. For general information on emergency lighting with Lutron systems, see Application Note #106 (P/N 048106) at www.lutron.com