- Design Studio 3.0 Manual
- Commissioning an Installation
- Managing N4 Hubs
-
Getting Started
-
Commissioning an Installation
- Commissioning Workflow
- Creating an Installation
- Managing N4 Hubs
- Building Groups
- Adding Devices
- Dividing Linear Runs Into Groups
- Using the Color Picker
- Managing Lighting Power-Restore States
- Building Scenes
- Building Shows
- Programming Ketra Keypads
- Enabling Sensor Control
- Enabling Emergency Lighting
- Integrating Third-Party Lighting
- All Analog Integration Profiles
- DMX Integration
- Integrating with Lutron
- Publishing: Saving Configurations to Devices
-
Maintaining an Installation
-
Saving Your Progress
-
Troubleshooting
-
Appendices
Adding Additional Hubs
On Design Studio’s Organization tab, the top-right pane has a tab labeled Add Hubs. (See fig. 25.) This displays any N4s connected to your LAN (Local Area Network).
Notice that you can change a hub’s channel before you add it. Only do this if you have multiple N4s that will be positioned close together in your installation. In that case, you will want adjacent N4s to be on different channels from one another to ensure ideal communication. If your N4s will not be close together, leave the hub on its default channel.